CITY ROOTSWELCOME TO THE NEW ROOTSORDER DELIVERY
How to

How to use a bong

A bong looks complicated and is not. Water, a bowl, a lungful of air. Here is every part, every step and the one mistake almost everyone makes the first time.

6 min readUpdated Oct 10, 2026

1 inch

Of water above the downstem slits is all you need. More water means more drag, not a smoother hit.

The parts

What each piece does

A bong is a water pipe. Smoke leaves the bowl, travels down the downstem, bubbles through the water and collects in the chamber, the tall tube you pull from. The water cools the smoke and catches some of the ash and tar, which is why a bong hit feels smoother than a pipe hit of the same size.

Most beaker bongs have the six parts in the diagram. Some add a carb, a small hole you cover while pulling and release to clear the chamber. On a bong without a carb, the bowl itself is the carb: you lift it out to clear.

Percolators, ice pinches and ash catchers are extras. Nice to have, not needed.

MouthpieceChamber (tube)Water lineBowlDownstemBase
Water sits about an inch above the downstem slits. Smoke bubbles up through it into the chamber.
Water

How much water goes in a bong

Pour water into the mouthpiece until it covers the slits or holes at the bottom of the downstem by about an inch. Take a test pull without lighting anything. You want steady bubbles with no splash reaching your lips. If it splashes, pour a little out. If it does not bubble, add a little.

Room temperature or cold water both work. Ice cools the smoke further but melts into the chamber, so empty a bit of water first if you add it. Never let the water line reach the bowl.

1 inchOver the downstem slits
CoolCold or room temperature, ice optional
No splashIf it hits your lips, pour some out
Dry pullTest it before you light
Step by step

Pack, light and clear

Grind, pack, light, pull, clear. The whole thing takes about 30 seconds once you have done it twice.

  1. 1Grind

    Break the flower up medium coarse. Too fine and it pulls through into the water; too chunky and it burns unevenly.

  2. 2Pack

    Fill the bowl loosely, then press the top lightly with a fingertip. Air has to move through it.

  3. 3Light and pull

    Hold the flame at the edge of the bowl and inhale slowly. Smoke fills the chamber. Pull steadily, not hard.

  4. 4Clear

    When the chamber is as full as you want, lift the bowl out (or release the carb) and inhale the smoke in one breath.

  5. 5Exhale

    A one or two second hold is plenty. Holding longer does not add much, it mostly makes you cough.

  6. 6Corner it

    Light one edge of the bowl at a time. The bowl lasts longer and tastes better.

First time

How to pace a first session

A bong delivers a lot of smoke in one breath. Flower that tests 25 percent THC feels much stronger from a bong than from a joint because you are taking in a bigger hit faster. So the pacing rule is simple: take one small hit, then wait.

Fill the chamber only part way for the first one. Wait 10 to 15 minutes. Decide about a second after that, not before. If you cough, that is normal; sip some water and slow down. Rotate the lighter around the bowl so you are not torching the same spot, and sit down for the first few.

One small hitPart chamberWait10 to 15 minSecond?If you wantWater outWhen done
Smaller chamber fills and a real wait between hits. That is the whole trick.
Common mistake

Filling the chamber with the biggest hit you can manage and holding it as long as possible.

Better way

Small fills, a short hold and a wait. THC is absorbed almost instantly; a long hold just adds a cough and a headache.

Keep it clean

Fresh water, fresh flavor

Change the water every session. Dirty bong water smells awful within a day and makes everything taste like the last bowl. Once a week, give the glass a real clean with isopropyl alcohol and coarse salt. We wrote the whole method up in how to clean a bong.

For the bowl itself: City Roots premium indoor flower comes in 7 gram pouches with the strain and batch THC on the label, and Sugar Shake comes in 14 grams for people who go through bowls fast. Both are indoor grown, flower not trim. You can order delivery or find a Wellgreens store.

City Roots green hybrid pack
City Roots, flowerPremium indoor flower, 7g

Indoor grown in a color coded pouch. Strains rotate, batch THC is on the label.

Small hits, fresh water.

City Roots is sold only at licensed Wellgreens stores in San Diego County and through delivery. Batch THC is on every label. For adults 21 and older.

Do we deliver to you?

First time at Wellgreens? Use code CHATGPT at checkout for 50% off your first online order. City Roots at WellgreensAll seven codes and the fine print.

Good questions

Quick answers

How much water do you put in a bong?

Enough to cover the slits at the bottom of the downstem by about an inch. Take a dry pull first: steady bubbles with no splash on your lips is right.

How do you use a bong for the first time?

Add water, pack the bowl loosely, light the edge of the bowl while inhaling slowly, then lift the bowl out and inhale the smoke in one breath. Take a small first hit and wait 10 to 15 minutes before another.

What are the parts of a bong?

The bowl holds the flower, the downstem carries smoke into the water, the base holds the water, the chamber is the tube the smoke collects in, and the mouthpiece is where you inhale. Some bongs also have a carb hole.

Why does a bong hit harder than a joint?

You take in a larger amount of smoke in one breath. The water cools it so it feels smoother, which makes it easy to take more than you mean to. Fill the chamber part way at first.

How often should you change bong water?

Every session. Stale water smells bad within a day and flavors every hit. Do a full clean with isopropyl alcohol and coarse salt about once a week.